
( Brand: Power Winch ), ( Manufacturer Part Number: 2203B ), ( Type: Windlass ), ( Custom Bundle: No )
The case has one stainless plug for oil level and fill. height at points of cleat is the treatment harder than aluminum it would appear.
U pay shipping 300 needs to be polished had id for 100 last time Power Winch model 2203B not a current production model completely rebuilt 12v horizontal windlass with wildcat this is wildly well built unit. About the case:the housing of gearbox is hard anodized aluminum. Similar size range Winches in Lorain's for instance only have single reduction gear sets. 5 fathead can be turned ahead of the motor.
6 has never had a chain in it. About the fathead:1 quality marine brass fathead is polished to a high gloss and virtually flawless. 7 the chain whelp will turn any time motor is running unless wildcat hand wheel loosened. 3 it is operated by a sprang clutch also, so that cannot turn backwards at any time.
About the chain whelp:1 accepts 3/8 PC proof coil. The boat it was on did not have any chain thick. 75 in diameter. The compound gearing really makes for a high load capacity.
All of the gears are 100 with no wear or corrosion at. These three piece stainless steel washer sets provide for excellent load control and thrust absorption. The case will hold quite a bit of oil and continue to splash oil, through primary bull gear, until it is very low in.
Max length bow to stern is internally, there are two more sets of thrust washer assemblies, one on the worm gear and shaft. The motor shaft enters unit fairly high up and drives through a sealed support bearing single row ball lip oil seal, which is new. Some dimensions:base bolt hole pattern: port to starboard, bow stern base holes 4 each are. The surface was treated with a white epoxy paint that in great shape and remains under new primer.
4 the chain whelp can be manually operated with a short round bar or pipe tube, through sprang clutch instead of more common and cheaper ratchet mechanism. Max width port to starboard is I have never seen so much machine work in one Winch. In other words, if you were to wrap a rope around this fathead, could pull on the loose end of and fathead would turn freely direction that it normally motor had been running.
4 also can be operated manually, the same way chain whelp is manually. 2 turns with the motor at all times is on.
3 there are thick brake disc on each side of the help, compressed by pressure plates operated hand wheel with sealing o-ring and three piece stainless steel needle bearing thrust washer assembly that is recessed into outer plate. The support is fastened to case with six each stainless bolts and locks. Hand wheel is 7.
Base measures 8 x at max. 5 full free fall on the chain by loosening hand wheel. Then, when all the slack is out of line, you can activate motor switch to let it continue with hard work. Base plate is.
The end of fathead is 4. The motor support is also hard anodized and machined with dial pins for alignment.