
( Brand: Seawell ), ( Manufacturer Part Number: 1203220SW ), ( Type: Anchor Winch ), ( Volt: 12v ), ( Maximum Anchor Capacity: 35 Lbs ), ( Anchor Roller: Davit ), ( Switch Control On Anchor: Power Up/power Down ), ( Rope Speed Down: 70 Ft/min ), ( Rope Retrieval Speed: 65 Ft/min )
Ideal for pontoon boats of all sizes. Tie the rope to anchor shackle. Look below the deck and check for any obstructions underneath desired anchor roller winch locations. This winch utilizes an anti-reverse internal clutch to prevent free-spooling.
ANCHOR WINCH OPERATION To lower the anchor press and hold switch in down position for a few seconds release. To raise the anchor, press and hold switch in up position. The anchor roller must be located at the edge of deck and extended over to allow clear when it is docked in. Locate anchor roller and winch on deck in desired location.
The anchor will free fall to the lake or river bottom. The BLACK negative - wire is attached to the battery terminal ANCHOR ATTACHMENT Attach shackle anchor shank eye. Bolt to deck. There are also holes for the battery lead wires so you can route through deck id desire.
The small hole on the buss bar flat stamped metal part with two holes is attached to colored post circuit breaker and large battery positive terminal. The wires and switch are all properly connected. Pontoon 35 Specifics Maximum Anchor Capacity: 30-35 lbs. This will lock the spool and keep it from letting more rope out.
Make sure there is enough space for the rope spool on winch to be centered anchor roller. Drill the holes. Shackle for anchor attachment included Anchor not included up to 30lb. To stop the rope from coming out of winch, press switch UP button for a couple seconds.
Note: There are several bolt holes in winch frame to choose from. The Pontoon 35 Anchor Winch allows you to raise and lower your anchor with the press of a button. Suitable for applications requiring heavier anchors, up to 35 lbs. Use fender washers and/or marine plywood under the deck to ensure greatest strength and spread load.
Using a marker, mark the anchor roller and winch mounting holes on deck. Remove winch and anchor roller.